Bootlegger
Admin
Joined: 2008-01-15
Posts: 9637
Age: 34
Location: Crossville,TN
 | | Subject: Arctic Cat 650 V2 belt light reset. Fri May 16, 2008 11:25 pm | |
| 1.With ignition Key in the OFF position - Belt cover side of quad.
2.Unplug belt sensor (2 wire)(flat connector) and the 4 wire harness (square connector) next to it (black connector)
3.Jumper the orange/green wire to the gray (possibly gray/green) wire right next to it in the connector.
4.Turn the Key ON (Belt light should flash rapidly then flash slow) Do not turn the key off until slow flashing light occurs. Whole proceedure takes about 10 seconds.
5.Turn Key Off
6.Plug in all connectors that were unplugged to do the reset proceedure.
7.Turn Key ON to verify reset (If belt light flashes you either need to take you bike in for the recall on voltage spikes in the CDI circuit) _________________ Suzuki King Quad 750Bootlegger Performance TunedMSA Nuke Wheels, 27" Interco Reptiles, ODI Grips, Twin Air Filter
3000lb. Xtreme Winch, VDI, Dalton HAC Clutch kit, STI Springs
CMG Custom Primary, HMF Swamp Series Exhaust, ASR Tie Rods
Tamarack Rear Box, Engine Ice, BP Snorkels, Full Ricochet SkidsCumberland ATV Riders |
|
bigcat
CATVR Junkie
Joined: 2008-01-16
Posts: 2156
Age: 37
Location: Cleveland TN
| | Subject: Re: Arctic Cat 650 V2 belt light reset. Sat May 17, 2008 3:15 pm | |
| I done this several times on the V-2 I use to own. |
|
Calendar
